|
Post by account_disabled on Oct 31, 2017 10:13:38 GMT
Hi, The air and acetylene pressures are okay according to the compressor and the acetylene tank readings, the igniter functions properly, the burner is aligned, there is no leakage from the lines, and everything has been suitably cleaned. The flame will not ignite. On the rare occasions in which it does, it goes out rapidly and we get an error message saying "no fuel pressure" or "no air pressure". What can we do to get this flame to light and stay lit? Please help. Thanks! I didn't find the right solution from the Internet. References www.labwrench.com/?community.posts/threadNo/165275/subject/AAS-Flame-Issue/Hand Drawn animation
|
|